Planned Services

Routine Service:

Residential/Commercial

PS Service Agreement Entitles You to the Following Services:

• We schedule planned maintenance calls.
• Priority emergency service.
• 10% discount off preventative maintenance.

• For 24 hour emergency, call 605-336-0545.
• We service all makes and models of equipment.
• Agreement can be canceled at any time by either party.

PLAN A (Air Conditioner)

• Clean condenser coil.
• Test electrical connections for tightness.
• Adjust system for optimum cooling.
• Check for oil and refrigerant leaks.
• Test safety devices.
• Check blower belt wear, tension and alignment. (if applicable)
• Test expansion valve and coil temperatures.
• Clean or replace air filter.
• Test refrigerant level.
• Check condensate drain.
• Lubricate as needed.

PLAN B (Gas Furnace)

• Clean and adjust automatic controls.
• Clean burners.
• Adjust combustion for optimum fuel efficiency.
• Test for combustion leaks.
• Test safety shutoff devices.
• Check blower belt wear, tension and alignment. (if applicable)
• Clean or replace air filter.
• Replace humidifier media at fall inspection.
• Check flue for satisfactory operation.

PLAN C (Electric Furnace)

• Clean and test automatic controls.
• Check all wiring for loose connections and condition of insulation.
• Check supply voltage.
• Check amperage draw.
• Lubricate as needed.
• Check blower belt wear, tension, and alignment. (if applicable)
• Clean or replace air filter.
• Replace humidifier media at fall inspection.

PLAN D (Heat Pump)

• Lubricate as needed.
• Test defrost cycle and reversing valve operation. Adjust air volume for maximum efficiency.
• Test safety devices and electrical connections for tightness.
• Check blower belt wear, tension and alignment. (if applicable)
• Check for oil and refrigerant leaks.
• Test electrical controls for proper operation.
• Check refrigerant level.
• Check refrigerant controls and coil temperature for maximum efficiency.
• Clean or replace air filter.
• Check condensate drain.

PLAN E (Combination)

• Combine Plan “A” with any other plan, “B” through “D”.
• Two seasonal inspections, and cleanings per year, to insure year round comfort and reliability.

Air Conditioning Maintenance and Safety Check:

• Install gauges and check operating pressures.
• Check voltage and amperage to all motors with meter.
• Check for adequate refrigerant charge and possible leaks.
• Check evaporator coil.
• Lubricate all moving parts.
• Check belt and adjust tension.
• Check filters.

• Check pressure switch cut-out settings.
• Check start capacitor and potential relay. (if applicable)
• Check compressor contactor.
• Check all wiring and connections.
• Check and adjust thermostat.
• Clean condensing coil.
• Check that condensate drain is open.

Furnace Maintenance and Safety Check:

• Check and adjust thermostat.
• Clean and adjust all safety controls.
• Clean burners and controls.
• Clean and adjust pilot assembly.
       a) check standing pilot
       b) check electronic ignition controls
  
• Adjust burner for efficiency.
• Check for gas leaks in furnace.
• Lubricate moving parts.

• Check belt and adjust tension.
• Check filters and change if necessary.
• Check vent pipe and draft diverter.
• Test fan control.
• Test manifold pressure.
• Test furnace for cracked heat exchanger.
• Test temperature rise.
• Test complete furnace cycle.